the VR4 Geniii manual says you should use a jumper only as a temporary solution. Bi-wiring them is the correct connection. Further, TVAD's recollection is correct, you should connect the wire to the mid/tweeter module, and the jumper down from that.
Different ways to Biwire speakers
I have a pair of Von Schwiekert VR4 Gen IIIs that are a two piece speaker with one pair of binding posts on the bottom speaker and one pair on the top speaker. Obviously, I can run two pairs of speaker cables to each of the two modules. Another way would be to run one set of cables to either the bottom or top module and run another set of cable between the two modules bypassing the amplifier. Is there any downside to this method?
2 responses Add your response
| Post removed |