Denafrips Pontus II Clicks Or Static?

I had the same issues about a year ago, Alvin had me do a firmware upgrade, that resoled the issues for 90% of the time, a month ago I did the new firmware upgrade, sound was good more detail, started checking left and right plus polarity, when I would Roon and play back was DSD left and right where backwards, through pcm play back it would be just the opposite and phase was off. Alvin replied that I had to change the phase through some programing he gave me, did and I thought problem was resolved, not , I had to go through 8 steps to get the correct I2s config, that also was effectting left and right ch.After all that now the small clicks and static are back. Just sent Alvin an email, had to share.

I have had this issue, but isn't frequent enough in nature to be a problem. At least to me anyway. The noise I get from my Pontus ll is a extremely soft low level pop, which happens maybe twice during a 3 hour listening session. While I would appreciate dead silence, it isn't that offensive to bother me. Pops, clicks, and snaps from vinyl are FAR more annoying than this.

@All

i just finished this entire thread and boy my head hurts.  The only reason I landed on this was after listening to Audio Science’s Amir explain the jitter, Dac clock vs source clock, pll and how that works and noticed he had not tested the Pontus ii, so I went a googling.

i purchased a Pontus ii 12th Anv. Which arrived today and is sitting boxed in my basement.  Now I’m afraid to open it 🙄.  Seriously, it’s replacing and old Burson DA 160 which I’ve loved over the years, but it seems to be choking on the new Eversolo A8.  Anyway, I am coupling it to an Audiophonics HPA Purifi D class and will report back should I hear any of those pesky pops.

Are you using the same cable, or different coax cables. Try switching and see if the problem switches.