Dedicated line questions

Whta exactly do u mean by seperate grounding?

The use of copper grounding rods only for your system mentioned in the above notes. I haven´t go that far to three separate and so forth but use two it´s worth the effort. What I actually did is I´m feeding my system out of the 220 volts electric range breaker (I use a gas one now) so it was a freebie (nice isn´t it)taking two 110 volts one for the amp and another for front end using dedicated grounding rods. Regards

I have recently renovated my house and added a dedicated room. I ran one 20A circuit to two outlets, and then installed two other outlets on another 15A circuit that also runs to other outlets in the house. I included the second circuit expecting to plug in a lamp, record vacuum, etc. After setting up, I have discovered that my amp sounds best when plugged into the dedicated circuit all by itself! This forces my front end onto the common circuit. My recommendation therefore is to run TWO dedicated circuits to your system, one for the amp(s) and one for the front end.

Korn... You can do what you're suggesting, but would only have dedicated power to one hubbell duplex outlet, and your ground would still be the same as for the rest of your house. If you have more than one empty breaker slot, run a line from each one for true dedication, but you still need a separate ground. Sol322 and Whknopp above are right re: grounding and more than one dedicated duplex outlet. Get an electrician, tell him what you want to accomplish and let them do their job-- that's actually what I did. I ended up with a submain panel, ran four dedicated lines off it and attached a dedicated ground to it as described above. You may be able to run several ded. lines from your main breaker box, but I don't know how you'd handle ded. grounding, ie that's where the electrician comes in. Again, good luck. Craig.

Korn... I just re-read Albert Porters comments on grounding, and he suggests not to run the ground off the sub-main (the way I did), but ground each hubbell outlet separately. My system now sounds great but Alberts suggestion makes sense but is more trouble to implement. At some point I may have an electrician run a ground wire to each outlet. Albert Porter knows much more about this than me. Craig