Dedicated 20 amp circuit - Electrician laughed!


I brought my electrician out to my house today to show him where I would like to install a dedicated 20a circuit for my system.  He laughed and said that's the stupidest thing he's heard and laughs when people talk about it.  It said, if you're going to do it, you have to have it separately grounded (shoving a new 8 foot rod into the ground) but even then, he sees no way there can be an audible improvement.

Now, he's not just an electrician though. He rebuilds tube amps on the side and tears apart amps and such all the time so he's quite well versed in audio electronics and how they operate.

He basically said anyone who thinks they hear a difference is fooling themselves.  

Personally, I'm still not sure, I'm no engineer, my room's not perfect, and I can't spend hours on end critical listening...  But, he does kinda pull me farther to the "snake oil" side and the "suggestive hearing" side (aka, you hear an improvement because you want to hear it).

I'm not taking a side here but I thought it was interesting how definitive he was that this not only WILL not make a difference but ALMOST CANNOT make a difference. 
dtximages

Showing 1 response by falconquest

I had the Romex wire from some long ago project on the basement shelf. I knew the work involved so one day I found some ambition, drilled the necessary holes and pulled the wire. I then bought the best breaker I could find and connected it to the panel. I used a good quality outlet and had my own dedicated 20 amp circuit for the cost of the outlet and the breaker. Oh, and lots of sweat and sawdust all over me (and the clean-up). I run my system through a balanced power unit which cleans up the AC and supplies consistent pure power to my system. it is dead quiet. I consider myself lucky that I am able to this but it is not hard. Most of it is just plain old manual labor. If you want to hear a bunch of discussion about N.E.C. just mention balanced power and electricians go crazy. I just smile and hit play!