2. home-theater
  3. 130509-59348

Crossover for music and movies

Hello, I recently bought a Marantz NR1506 and went through the Audyssey setup process; tweaked the settings a little bit from there, and it's sounding great. My problem is there is no crossover set on the Front L/R speakers (floor standing), which is good for music, but I would think for movies I would want a little bit of HPF on those as to not interfere with the sub.

Maybe this is a stupid question but is there a way to have different settings for music / movies, or stereo / surround?

Thanks
128x128tbhockey
4 responses Add your response
swampwalker's avatar
swampwalker
5,138 posts
 
Don't know your AVR in particular, but usually there is a way to designate the front L & R speakers as large or small, which will set their high pass frequency.  Then you can match with the proper low pass frequency for the LFE channel,  I always allow a moderate amount of overlap. 
auxinput
2,920 posts
 

There are two ways that a movie DVD/bluray will play bass (depending on how it is mixed/engineered).  Sometimes bass effects will come from the left/right channels.  In that case, they will be sent to your left/right speakers if you have set your left/right to be "LARGE" with no crossover. 

Other times, bass effects will come from the ".1" LFE channel of the movie sound mix.  In this case, it will only be sent to the subwoofer, unless you have the subwoofer disabled on the Marantz.  If you have no sub, the bass will be sent to your left/right speakers.

I have had movies that use both left/right channels as well as the ".1 LFE" channel for different bass effects.  In your case, you could set the left/right speakers as "LARGE".  Or you could set them with a very low crossover point such as 40hz or 50hz.  This would allow the left/right to play most of the music low-end, but the Marantz would still send very low bass effects to the subwoofer.

m-db's avatar
m-db
971 posts
 
The manual for your receiver appears to be quite extensive including an appendage for the Audyssey equalization as it pertains to home theater use. After a cursory look I didn't see the ability to set up multiple equalization settings which is not to say it doesn't exist.

I find the ability to adjust the subwoofers parameters by remote control from the listening position in my music only system incredibly useful with some recordings. The Velodyne Digital Drive Plus line of subwoofers offers six multipal preset controls. They can also be used for a separate HT or music only system connected at the same time but used by one or the other while in use. There may be other brands that do this that I'm not aware of.  

tbhockey's avatar
tbhockey OP
4 posts
 
Thank you very much for all the tips, guys!
Log in to respond
More to discover
80x80
Kii Audio BXT Modules
80x80
B&W (Bowers & Wilkins) DB1D
80x80
JL Audio Fathom 212 V2