Copland DRC205 digital room correction

Thanks all. Since I don't have a tape loop in my pre this is looking more problematic since I listen to both vinyl and digital. Can the Copland only handle one input?

Inputs, Mic. Position and Filter Configuration

Hi Oscar44 and rhljazz,

The Copland has only a single input. However, you could use an input switch such as you might find in an inexpensive passive preamplifier. The volume control would be easy to bypass. I feel your pain. Now that I've decided to keep the Copland, I'm replacing my otherwise satisfactory PS Audio GCC-100.

When I first saw the DRC205 a RMAF, I asked whether the unit limited listeners to a single position. The representative answered that the improvement was audible over a wide area. This has certainly been my experience.

The maximum gain/attenuation for any filter is +/- 6db. That said, this can be applied in addition to the automatic setting which forms the basis for custom curves. I am using two filters (see earlier post) which have more than the recommended gain and Q without ill effect. Of course, since this falls outside the manufacturer's specifications, the usual caveats apply.

Wazmoh, I have the DRC205 connected to my system (Musical Fidelity XRayV3 into DRC205 into Bel Canto S300ui integrated amp) I have tried hooking up to three different computers 1 laptop and 2 desktops all with window XP. I cannot get the computer to connect up with the DRC205. I have tried installing the drivers but the computer never sees the proper files. According to the instructions I should see the installation wizard ask for the "EVAL232 Board USB Serial" software to install the file "ftdiunin.exe" but the computer never shows this. And then the computer is supposed to show installing the "USB Serial Converter" with the file "FTLand.dll". Did your installation go as the instruction show or did you do something different to get the DRC205 to connect to your computer.

What does the DRC205 retail for?

Bigcahuna2000, I have the same problem. I received my DRC205 on Saturday. During installation of the software, right before the "finalize" screen it comes up with a page stating something to the effect of USB driver not found. The Copland software installed on my laptop (windows 98) but I have no communication with the DRC205. The instruction page showed a diagram about trying different com ports but that was not successful for me either. Perhaps there is a software problem or internal problem with a certain batch. I don't know the serial number of mine without going home and looking. Of course the store I purchased it from is closed as everyone went to CES.

So far, I prefer the basic flat filter. The bass definition is much improved. It has a range of brightness through the lower treble/upper mids that I would like to alter but can't, due to the computer problem.

jla, the current retail is 2995.00.