Connecting Subwoofer’s to Willsenton R8


I have been wanting to add 2 Rel S/ 510 or 812 subwoofers to my system. I have a Willsenton R8 (upgraded tubes) , newer Cornwall 4s speakers. I am confused with the many solutions I have read and even some say you can’t add subwoofers. I also have a McIntosh C2500 tube preamp running a separate system . If anyone can tell me in simple terms how or if this can be done. 
thank you

tooth2th

OP, for pair of subs, use the supplied high level Neutrik Speakon 3-lead cable as below,

Twist red and yellow wires together of LEFT REL sub and connect them to the L channel positive binding post. And connect black wire of left REL sub to the L channel negative binding post. Repeat these steps for your RIGHT REL sub / right channel.

In some instances, twisting red and yellow wires together may result in exceptionally high gain (output) from the RELs. If this is the case, please remove either the red or yellow wire from the twisted pair and use electrical tape to mask the loose wire. This will reduce output by half and restore a natural dynamic.

Can the same wires be used at the speaker binding posts instead of at pre/amp ?This would reduce cable length needed. 

REL sub's will work with essentially any amplifier/integrated amp since they connect directly to the binding posts.  My question (and not to hijack this post) is there a way (ie easy internal mod) to pull the variable signal off say the output of the volume control and repurpose one of the input RCA's to act as a sub out?  I have a modded R8 which I greatly enjoy.