2. amps-preamps
  3. 176088-134553

Connecting monoblock tube amps to single subwoofer.

Hi all,

I have added a REL5TX sub to my system which is driven by VTL225 monoblocks.Currently the sub and amps are connected via the low level outputs on my preamp. I would prefer to use the high level connection to the REL by direct  connection to the the VTLs. I am concerned about creation of a ground loop that will cause hum on the system. I have been told that the ground loop can be avoided by running a ground wire directly between each amp. Is this a possible solution, and if so, where / how should the ground "jumper" be connected to each monoblock?

Many thanks in advance for any comments or suggestions.

rbanathy

Showing 1 response by bdp24

bdp24's avatar
bdp24
10,096 posts
 

@mike_in_nc: In fact, the exact opposite may be true. Why add the commonly-admitted limitations of tube amp output transformers to the signal if not necessary?

Brian Ding of Rythmik Audio offers his subs with plate amps that include provisions for both high-level (power amp) and line-level connection. He prefers and recommends line-level for best sound quality.

More to discover