Yes, you understood correctly. When each of the amps is used in mono mode, and each amp is connected to just one 8 ohm speaker, you would use the 16 ohm tap (also referred to as the 16 ohm terminal). As mentioned earlier, be sure to also connect a wire between that 16 ohm tap and the 16 ohm tap for the other channel of the same amp.
That is explained in the manual Tony (Tls49) linked to earlier. In mono mode the 16 ohm tap in effect becomes an 8 ohm tap, and the 8 ohm tap in effect becomes a 4 ohm tap, and the 4 ohm tap in effect becomes a 2 ohm tap, and the 2 ohm tap in effect becomes a 1 ohm tap.
Regards,
-- Al
That is explained in the manual Tony (Tls49) linked to earlier. In mono mode the 16 ohm tap in effect becomes an 8 ohm tap, and the 8 ohm tap in effect becomes a 4 ohm tap, and the 4 ohm tap in effect becomes a 2 ohm tap, and the 2 ohm tap in effect becomes a 1 ohm tap.
Regards,
-- Al