2. amps-preamps
  3. 154699-140500

comparing two pre-amp/phono section buying scenarios, so weigh in!

Hi. First time poster. Based on what you know about phono stages, and assuming the cost is about identical, would you suggest (assuming the specific equipment below):
1. buy a used Conrad Johnson ET3 with the on board phono stage (assuming the correct gain setting for the cart HG or LG)
or
2. buy the same used Conrad Johnson ET3 (line stage only) and then buy a a $400 Moon 110 LP V2 phono stage.
again: the cost total is about identical, save the cost of interconnects.

My equipment may or may not be relevant to your answer, but I have a project Debut Carbon TT with an ortofon Blue cart, but that will eventually change with my next upgrade. I'm replacing an 80s era SS Mcintosh pre amp and I'm running Thiel 1.7s with a Rotel RB-1582MKII
Thanks for any help
rakod
rakod OP
5 posts
 
@atmasphere 
no. Not stuck to it.  Just always liked the value and the sound of the CJ stuff. What’s your idea?
atmasphere's avatar
atmasphere
11,794 posts
 
For that kind of money you have a lot of options.
Do you have or are you planning a low output moving coil setup?

rakod OP
5 posts
 
I know that specs aren't the same as reviews, and aren't the same as your own opinion, but what I'm getting at is: are these two phono stages in the same arena?! (The Moon is much more versatile, that much I know and I consider that in terms of upgrading upstream equipment. and it reviewed very well)

Conrad Johnson on-board phono specs:
ET3 Optional Phono Stage
  • High Gain Version
    54dB
  • Low Gain Version
    40dB
  • RIAA Equalization:
    +/- .25 db 20Hz to 20kHz
  • Hum and Noise:
    -80dB relative to 10mV input
  • Phase:
    phase correct
  • Tube Compliment:
    High Gain Version
    3x 12AX7
    Low Gain Version
    2x 12AX7, 1x 12AU7
Moon  110 LP V2 phono stage specs:
  • Circuit Layout: Mirror-image symmetrical circuit
  • Single-ended inputs1 pair (RCA)
  • Input Impedance - Adjustable10Ω / 100Ω / 475Ω / 47kΩ
  • Input Capacitance - Adjustable0 / 100pF / 330pF / 430pF
  • Gain Level - Adjustable40dB / 50dB / 54dB / 60dB / 66dB
  • CurveIEC / RIAA
  • Signal-to-noise Ratio (full scale @40 dB gain)104 dB
  • Signal-to-noise Ratio (full scale @60 dB gain)87 dB
  • Frequency Response20Hz - 20kHz (± 0.5dB)
  • Intermodulation Distortion0.002%
  • THD (20Hz - 20kHz)0.002%

rego
378 posts
 
Have confidence in CJ to do what they do ... 
rakod OP
5 posts
 
@atmasphere 

If/When I move away from this TT (and possibly this cart, which is a high gain unit requiring a low gain setting), it's quite possible I'll move to low output. Sure. Trying to keep options open...I move slowly on these things.
Thanks
atmasphere7,969 posts02-13-2020 11:07amFor that kind of money you have a lot of options.
Do you have or are you planning a low output moving coil setup?
More to discover