2. amps-preamps
  3. 1152294921

Cleaning tube pins and sockets

I have an older tube preamp which uses four of the type 6922 tubes. I have NOS tubes in there now. Once in a while I get some noise from one of the channels. Reseating the tubes clears up the noise problem. Obviously, it's time to clean the contacts. I can easily clean the tube pins but how can I clean the socket? The socket is soldered into the PC board. I was thinking about using a toothpick wrapped with a small piece of the thick blue paper towels that are sold in auto parts stores and working the toothpick in and out of the socket holes. I have Caig DeoxIT and ProGold on hand. Can I get by with either or both of these? I read that ProGoldPlus is recommended for high temp applications such as tubes. Any tips (or warnings) from you tube guys?
Thanks
pmi_guy
5 responses Add your response
riffer
362 posts
 
Square toothpicks are good. Don't wrap it - you will probably end up loosing the the paper in the hole and having to get it out.

Also, I found some small brushes in my local drugstore in amongst the toothbrushes etc.
pawlowski6132
592 posts
 
If you're using NOS tubes for the first time (i.e., they haven't been used in 50 yers) it's usually something inside the tube that's settling. I don't think moderately dirty pins would cause crackling.
eddaytona
216 posts
 
Do a discussion search for this:
Cleaning tube sockets

This will give you your answer.
waveman's avatar
waveman
79 posts
 
Pipe cleaners. Just remember they have a wire in the middle so use caution.
pmi_guy OP
72 posts
 
Thanks, all.
I'll try toothpicks and DeOxit first.
Log in to respond
More to discover
80x80
Conrad Johnson Art 88
80x80
Aurorasound VIDA Mk.II
80x80
Audio Mirror Addiction Power amp monoblocks