The fancy term "Attenuator" disguises the fact that we are talking about a couple of resistors. It's just a voltage divider. I would simply build it into the input jacks of the preamp. Do it with ordinary resistors, and when you get the volume right you can replace them with "audiophile" resistors if that makes you feel good.
CD output voltage too high for preamp: what to do?
I have an Audible Illusions preamp which is designed for a 1.5v input signal. I am told that this is standard. My Ayre CX-7e puts out 2.25v. They play beautifully together but I have too little control over volume: I cannot use the preamp vol controls beyond 9 o'clock because it is way too loud. Likewise it is hard to get just the right volume in the limited range available. This is worse with some CDs for reasons I do not know.
Audible Illusions will change the preamp attenuation board for $275, but before I do so I wonder how others have dealt with the problem of newer CD players with higher outputs than their preamps were designed for.
Audible Illusions will change the preamp attenuation board for $275, but before I do so I wonder how others have dealt with the problem of newer CD players with higher outputs than their preamps were designed for.