CAT SL-1 Reference repair

I had that burn out myself on my prev CAT preamp. I emailed the factory & they shipped me a replacement bulb free of cost. Try contacting the factory.

The power switch lamp in power supply unit is gone. The model number of the lamp is AML91LA73 14V lamp. It can be ordered from many place, eg. Newark, etc.

You are right. The plate is ~90V after tube heating up. Thank you.

plate voltage in 6dj8 must be 90V.

Thank you czarivey. I checked the bias voltage last night, all the plate voltages are very low <20V. I looked into the power supply and found a intermittent connection on high voltage regulator transistor TIP50. I solder it. Now the CAT is alive!  But one thing i notice that V1 / V2 (6DJ8) plate voltage is about 90V instead of 180V that someone suggested. Is this normal?

Yep check values of bias resistors by removing them from circuit and if one found out of spec, replace resistor and tube. Usually bias resistors goes bad when tube does. Replacing DC caps in the chain of grid bias supply  would also not hurt preventative.
Also would retouch existing solder in case if I spot cold joints. With tube electronics it's very common and often done before any troubleshooting begins.

Thank you all for the replies. I tried both MC and MM, neither works properly. I checked up tubes, all of them light up. Thank you czarivey, I'll follow your steps to check the bias.

Assuming your TT was working fine in your previous preamp and both channels are equally affected, do you have a digital source hooked up to the line stage? If so, turn it off and then run the phono section. If you get the same thing then it has to go for repair if changing the tubes didn't help. The only thing common to both phono channels is the HT supply to the output 6922 and it looks like CAT uses n-channel mosfet regulators to the plates.

 if you're onto DIY,
first, check if tubes light up on you phonostage.
2nd do visual on phono-board by checking any signs of burning or caps leak with magnifying glass
3rd if tube(s) light up, you have to measure bias current or voltage accross bias resistor of each tube. bias resistor can be found in grid circuit and the grid pins can be identified via internet just by querrying your tube ID.
4th, if you're local enough to raleigh nc, i can accept your unit and make it work and if not, unfortunately i don't do shipping turnarround. 

best to call CAT in upstate NY & have them repair it. They know their products well & can fix any of their old products.
You will never find a sch of any of their products on the web as they never release any of this info. All of their topologies are proprietary & many of the internal components are also proprietary. If you’ve opened the box you’ll see that none of the caps have any values on them - just a catalog number. The CAT factory has the decoder key to match catalog number to cap value.
Let the factory take a look & tell you what’s wrong....
excellent preamp, if i may say so.

Are you using a MM or MC cartridge? There are loading plugs for the MC's if they are low output.

If you bought it at a good price, sell it and buy one that works

How about Ken Stevens?    585-359-2700