Cartridge Loading- Benz LO.4


Looking to see if anyone has experience with proper phono pre-amp impedence for this cart. Specs say 200-47K. Quite a range and I'd like to narrow it down a bit. Any guidance would be appreciated. Thanks!

Regards
Jim
jimbo3

Showing 1 response by ozzy62

I have the L2, which is the newer version of your cartridge with the same output. A lot will depend on your phono stage, but I have mine loaded @ 300 ohms. I have found that it sounds good most anywhere below 1k ohms, but 100 was way too much. It is very flat and rolled off sounding at that loading.

Oz