Can you run the HANA SL MC at 100 ohms?

Compared 300 to 1k on my Hana SL and Plx-1000 with Cronus Magnum 3.
For my system and ears, sounds amazing and absolutely perfect at 1k. At 300ohm sounds a little muted.
This is now a dream set up for me, goose bumps with some of these top notch 45 rpm albums !!!

Cartridge loading is very system dependent. I never loaded my Benz carts until I got into my Brodmanns and Ref110 amp. I can hear the difference between 40 and 50 ohms-ain't huge but I can hear it AND have a preference. I've settled on 100 for the Hana ML. This is in my #2 table which has an old Fidelity Research FR64fx(removable headshell) & I've got several cartridges that are easy to swap. Don't scrimp on a transformer if you go that way. The difference can be huge BUT each one's different. I borrowed a $2600 Dynavector and it wasn't as good in my system as an old Audio Interface. AND I'm using a transformer INSTEAD of the hi gain setting on my ARC Ref Phono 2! This can be an alternately infuriating and engrossing hobby. Thank god for music. BTW if you know a friendly tech, he might make loading plugs up for less than DB Sys. Find a couple old interconnects with decent plugs that can be taken apart-I used cheap old Monster Cable and they will be better than DB's.

I've owned the Hana EL and currently own the SL. They have the same internal impedance (30 ohms) and a similar sound, but the SL is more resolving in the mids and highs. I load the SL with a Bob's Devices transformer that feeds a Line Magnetic tube phono preamp. I have two of the Bob's: with the Sky 20 and Sky 30 Cinemag transformers, so I can load at 10, 15, 20, and 30 to 1. Respectively, that's 470, 209, 118, and 52 ohms loading. In my system, there is a benefit to "loading down" the cartridge that goes beyond keeping RF away from the preamp (as atmosphere mentioned). There is a presence, a focus, a palpability, that comes with lower loading, that makes the sound more "real" in my system, and which has been written about by many, including the late great Art Dudley (RIP). But loading it down too much can also create a closed-in sound that loses some sparkle. So there's a trade-off (like almost everything in life). For the Hana SL, I most often load it with the 15:1 transformer, which is 209 ohms, which gives me the best in terms of openness and palpability. It sounds amazing in my system; better than the Denon 103R, Dynavector 10X5, and Dynavector 23R that I also own.

winefix

I have the Hana SL & ClearAudio Emotion, after reading your post (and others) I just changed resistance from 470 to 1k in my Moon 310LP. BIG difference, 1k is SO much better, 470 was as you said muddy, main vocals were not focused. SO glad I made the change. :)

Manufacture recommends >400 ohms for Hana SL, but 470 wasn’t enough for me. I should have tried both when I bought it...

Now try 47K, if your phono stage permits it.