2. amps-preamps
  3. 1119571468

Can anyone tell me what happened?

My tuner was on. My preamp (anthem AVM-30) was on and set to a selection which has nothing attached to its in or out terminals. My amp (Cary/AES 2A3 SE-1) was on. I replaced the 6SN7 tubes last evening in the amp. Everything played beautifully last night.

The system was left in this "on but no load" mode as I do sometimes when I leave the room for a few minutes.

I returned to a deafening hum coming from the speakers and smoke coming from the preamp/processor. Turned everything off and let it all cool down.

It is playing now without problems except that the music is lifeless.

What could have happened???

Any ideas will be greatly appreciated.

Thanks
pkemery

Showing 2 responses by biomimetic

biomimetic
252 posts
 
I had this same experience with a NAD - a cat had peed on plug strip. Cat fine, amp not. Thanks to the cat, I now have tubes.
biomimetic
252 posts
 
In all seriousness though, with a couple o' minute to think... Is it possible that the overall voltage is much lower in your Anthem, and the Cary much higher... and in an attempt to equalize, your Anthem started cycling up with the Cary's unreleased voltage? I have had similar issues, and always think that it is better to go tube to solid, rather than solid to tube. I used to have a Marantz that was a digital processor, and would do the safety turn-off thing if I ran the tube preamp through its bypass, and then to the amp, verses ran the Marantz to the tube preamp. It had been fine when I had a pair of MA500's. Went over to a Rocket and started having the problem. Weird but true.
More to discover