Cable Suggestions

Check out Phoenix Gold ZeroPoint Pro,teflon dielectric,70 fine strand cast mirror finish FP copper twisted pair balanced,triple shielded,directional drain grounded about
60 dollars 1 meter(1/2m available as well)if shielding is
not wanted you can remove it,the materials are quite nice
at this price.IMHO

Canare Starquad mic cable. Cheap, quiet, and linear. I'm using it on a pair of Earthworks mics on my Steinway B into an Alesis Masterlink into my Aleph P into my System in the same room, and I'll be damned if sometimes my Parsifal Encores (which flank the B) sound BETTER than ME live!
Course part of that's the spaciousness offered by the 27"
"berklee pair" micing technique, I s'pose.

to Audioengr:
I too am using a pair of Kimber IC's at the present, and find the top end a little bit too much...would you mind elaborating on the mods you suggest?

AE, I guess you mean sibilance as form of IM distortion. That can be measured, do you have any data to support your theory?

steve

Shielding has nothing to do with it. Shielding will just increase the capacitance, which is not a good thing. Your problem is sibilance from poor conductor metallurgy. It is often perceived as high-freqency harshness or brightness. You need single crystal or perfect crystal conductors to eliminate this.

BTW - once you have good IC's and speaker cables, your components sibilance will probably stand-out, particularly CDP or Transport and DAC. Only mods will eliminate this.

Try some Acoustic Research directional cables from Bestbuy.com for around $13.00 a pair.Part numbers APO-30 and APO-31..take the rest of the money you saved and put it in some more sacds.Plug them up and be amazed at the perfomance!
Good Luck!

A properly shielded cable will likely help, as suggested by other inmates. Sounds like EMI/RFI emissioms from equipment/surrounding. The PBJs does not seem to be properly shielded.
Good luck.

Other than Nordost, I have never know a cable to cause "too much high end." Try the $99 for 1 m. RS Audio Cables. They offer a 30 trial. I think they are truly exceptional and better than most $2k and above cables. I have two pairs thus far.

Look for a used pair of Cardas Quadlink 5C interconnects, which should be available in your price range. These will add some warmth, without loss of detail.

Signal Cables http://www.signalcable.com
Frank is a cable maker here at the 'GoN. His products represent an amazing value for the money