Don’t worry about it. I have all my tube gear in cabinets and never a problem. Take a look at my system. Those tube amps have been sitting there for years without any problem. And they sure get a lot hotter than your AR preamp!!
Cabinet clearance for Audio Acoustics LS16 tube pre-amp?
I am in the process of designing a built in cabinet for my stereo system. The owner's manual for the Proceed HPA2 amp is very clear about clearances for air flow. And even in the summer it almost never feels very hot as it has enormous aluminum heat sinks with completely open airflow from top to bottom.
The owner's manual for the LS-16 does not give any specifics. It says things like "adequate airflow" and that with a closed back cabinet, which mine will be, an exhaust fan is "desirable". That's about all they say. And it runs noticeably hotter than the amp. The top is never too hot to touch by any means but it is warm to the touch. Currently it sits on top of basic component stand and is up on some raised blocks so it gets all the airflow it could possibly need.
I could put it on top of the built-in shelves but I'd prefer not to. I'd also prefer not to have an exhaust fan humming along all the time. But, I don't want to shorten tube life or hurt the unit either.
Any recommendations? Precautions? Prior experience with your set-ups with tube pre-amps?
Thanks,
George
The owner's manual for the LS-16 does not give any specifics. It says things like "adequate airflow" and that with a closed back cabinet, which mine will be, an exhaust fan is "desirable". That's about all they say. And it runs noticeably hotter than the amp. The top is never too hot to touch by any means but it is warm to the touch. Currently it sits on top of basic component stand and is up on some raised blocks so it gets all the airflow it could possibly need.
I could put it on top of the built-in shelves but I'd prefer not to. I'd also prefer not to have an exhaust fan humming along all the time. But, I don't want to shorten tube life or hurt the unit either.
Any recommendations? Precautions? Prior experience with your set-ups with tube pre-amps?
Thanks,
George