BS Node 2i: WiFi or Ethernet..?


Greetings from snowy Chicago.

My rig:

Bluesound Node 2i
Chord Qutest (with Teddy Pardo LPS)
Belles Soloist 1 int am
Dynaudio Special 40s

I stream Tidal mostly and my router is in the same room as my Node in the basement and I have very strong wifi signal.
But, cant direct connect the Node to network w/o running a 15’ cable.

My question:

- Has anyone heard better SQ results by using ethernet connectivity with Node 2i compared to just using WiFi?
- Am curious if using a wireless "access point" then connecting it to Node 2i via ethernet would sound "better".

Any thoughts or experiences out there?
Thanks.

ianrmack

Showing 3 responses by cakyol

Ethernet wired connection will ALWAYS be better. It will always provide a more reliable medium.

If wifi works perfectly, there will be no difference. However, since wifi is almost always prone to distance and/or interference and connectivity issues, it will always be inferior to ethernet wired connectivity.
feldmen4,

I did not quite understand your issue but if it is a distance problem, you can always use a learning bridge to extend your range and connectivity.

This device will do it for you perfectly.  I have 3 of these at home and ALL my connections are wired to the back of my home router and I have absolutely no connectivity or interference issues.

https://www.amazon.com/NETGEAR-Ethernet-Unmanaged-Internet-Splitter/dp/B00QR6XFHQ/ref=sxts_sxwds-bia...

alephresearch

Ethernet wire does not introduce or capture any noise to its destination.  All is taken care of by the checksumming and error correction codes.

There should be absolutely no problems.  I use more than 100 ft of ethernet cabling almost everywhere in my house coz they all first go up into the attic and then down, and I experience absolutely no issues.

As long as you do not exceed the maximum length requirements of a category 6/7/8 cable, there should be NO problem.