Brown Electronic Laboratory amplifer 1001 MV

The BEL 1001 MK5 is a great amplifier!  I once owned one. Sold it, a regrettable mistake for sure. Would not be hard to replace the RCAs.

I you don't solder do you have a friend who does?

Tools required would be a soldering iron, solder and I generally

use needle nose pliers for loosening/tightening the nut securing through chassis RCA's.

Can't tell from the photo I posted, but assume that non-conductive washers are used to isolate the RCA unit from the case/chassis, plus the RCA shaft would need to centered without any contact to the chassis (not a big deal).

This said, due to the small gauge of the wires and whatever material is insulating them it's a job best performed by someone experienced with de-soldering/soldering small wires.

Due to declining vision that started 10 years ago I would have to use heat sinks (just small copper flat jawed alligator tips) and would also insert a male RCA into the new female plug being installed (additional form of heat sink), but 15 years ago it would have been a simple 5-10 minute job without using the extra "suspenders".

Just saying that replacing them is not difficult (they are not board mounted), but you need to have experience working with small gauge/short wires that you wish to remain intact/useable.

DeKay

thanks to all who helped with this.  The problem is that the connections from inside the amp into the RCA female plug was inserted way into the plug and inhibits the insertion of a standard RCA plug.  So am replacing the plugs.  Turns out not to be a major issue and even I can do that level of soldering.  the question of why the plugs were constructed as they are is unanswered. time to move on.

Thanks to all 

Kenema (a town in Sierra leone if anyone is curious)

Nice that you have the skills to replace them.

Somebody like me probably installed the old ones.

DeKay

Brooks Berdan Audio in Monrovia, California has done repairs to BEL Amps in the past. A friend of mine took his BEL amps to be repaired.