Bi wiring?

Since the power ratings are so different, you'll need to balance them out.

Since the voltage sensitivities are probably different, you will need to find a way to balance them. Power output capacity is irrelevant.

BTW, if the 300wpc amp is a good one, it will do just fine alone and without biamping. You do not need to have an amplifier capacity equal to the speaker's maximum rating.

Kal

YOU MUST ADD a crossover to feed the right stuff to each half of your speaker.

No. You must REPLACE the inbuilt crossover with the proper custom external one if you want proper biamping. This means that you must REMOVE the inbuilt on in the speakers in order to avoid cascading the two.

OTOH, you can leave the inbuilt one in place and not INSERT an external one but this will minimize any advantages of bi-amping.

You cannot use BOTH crossovers.

Kal

Timrhu wrote: Gpetrons962, confused yet?

If so, then forget bi-amping.....which would be my advice anyway.

Kal