2. amps-preamps
  3. 1096483540

Bi-amping with no pre-outs

I would like to add an amp to push the woofers in my NHT 2.4�s, but my receiver has no pre-amp outs. What it does have however is a single sub out, which I use for its intended purpose and would like to know if it is possible to split the signal for bi-amping purposes? Possibly to an Adcom GFA...
dcconners

Showing 1 response by marakanetz

marakanetz's avatar
marakanetz
5,473 posts
 
Eldartford,
Receivers that have configured to use jumpers between pre-out and amp-in usually run with amp disconnected thus cannot be used in bi-amplification.
The skillfull tech should just connect a pair of RCA without disconnecting an input to the amplifier i.e. in-parallel.
More to discover