i just un-bi-amped my nht2.5i, they sound so much better. seems to have twice the power. i couldnt understand why i had no highs, so i used just used my carver tfm15 to power the whole speaker. i had been using my hk avr20ii to power the top half. 65 wpc to the highs 100 wpc to the lows. may have sounded ok if the 2 amps were the same make and power.
Bi-Amping My Mirage 3si's
I would like to change my set-up from Bi-wire to Bi-amp.Is it as easy as running 2 feeds from amp to each speaker (1 to low &1 to hi)and then running y outs on left & right channels on my casablanca and then down to amp?Some questions i have?
1)Will Bi-amping better my set-up
2)Can anyone recommend cables(balanced interconnects& speaker cables)
3)where would i get y outs-i would need balanced type
My system
Mirage speakersM3si/MCSI/Bpss-210sub/omr2
Theta CAS3pre/Pro-Aragon3005amp
onkyo1000dvd-Cardas speaker cable(5cQuad)MIT-Ter2 RCAinterconnects.Need to change to balanced due to upgrade on Cas3 to extreme dacs Thanks Kevin
1)Will Bi-amping better my set-up
2)Can anyone recommend cables(balanced interconnects& speaker cables)
3)where would i get y outs-i would need balanced type
My system
Mirage speakersM3si/MCSI/Bpss-210sub/omr2
Theta CAS3pre/Pro-Aragon3005amp
onkyo1000dvd-Cardas speaker cable(5cQuad)MIT-Ter2 RCAinterconnects.Need to change to balanced due to upgrade on Cas3 to extreme dacs Thanks Kevin