Bi-amping my KEF R3 Meta speakers.


This might just as well fit into the amp section or maybe just why bother. Since I had my M80 Yamaha amp repaired, I find myself with two power amps. The other is my Emotiva A2. Since I had them both, I purchased a simple A-B switch box so I could compare the two and see if I liked one better than the other, My 76 y/o tinnitus ravaged ears can detect no difference. Both have more than enough grunt to drive the KEFs. The Yamaha is rated a 330wpc in 4ohm and the A2 is around 250. So, it just struck me, what about bi-amping.

OTH, why bother? The amps are way under stressed as I'm feeding the lows to dual amplified subs. What say you?

128x128llg98ljk

Theoretically the amp that drives the woofers has the challenge of physically pushing the woofer and dealing with all the electrical interactions from that task, so splitting that job gives the tweeter amp the benefit of not having the side effects of handling that task. Your situation is most feasible for a passive horizontal bi-amp configuration. Your two amp choices are relatively similar compared to say a tube amp, plus the passive crossovers remain unchanged, so I’d surprised if the difference is significant, but it might be audible.

How much change it makes is an unknown, but since you have both amps on hand it’s not a huge deal to experiment. You might find that one does better as the woofer amp, and the other on the tweeters, so try both ways if you proceed.

I had to look up passive horizontal as I was not familiar with the term. One source said it was often referred to as "fool's" bi-amping.

In light of what you say and what I gleaned from quick research, probably best to leave as is. My preamp has both high and low bass management. I currently have it set at 60hz so the amps in the subs are handling the low end and my other two can loaf along with stuff above 60 or so.

I'll continue to arbitrarily switch them to keep the juices flowing so things don't dry out. Thanks for the info.

Implementing powered subwoofers into your system is essentially active horizontal bi-amping, so you’re bi-amping already. yes

Sensitivity of both amps is likely different - you need to adjust signal levels.  

https://forum.audiogon.com/posts/2709516

Kijanki, Thay has not proven to be an issue. As I stated, in the current setup I am only using one amp at a time using an A/B switch box. I've noticed no issues so far. I always start up my rig at a low volume level and don't really notice that I have to crank the volume up differently for either one.