2. speakers
  3. 988677544

Bi-amping for me?

My new (used) speakers have this funny bridge between the terminals which I correctly assumed are for bi-amping. The dealer I boughtthe speakers from thought that I would get some added benefit from bi-amping. I'm going to ask a stupid question and please don't jump down my throat: do both amps in this scenario have to have the same output? The speakers run at 4 Ohms so can I assume that tubes would not suffice in either scenario. The speakers sound good with my present amp (threshold S300). Are there any articles you could recommend? Also would like some guidance with x-over units...From what little I understand, this is a controversial subject (i.e. the proposed benefits of bi-amping). Thanks.
russellrcncom

Showing 1 response by sqjudge

sqjudge
96 posts
 
It sounds as if you might want to put a tube amp on the high frequency section of your speakers. This could work out fine as long as you match up the gains like Ligi has mentioned. You could take the higher gain amp (I assume the higher power one) and attenuate the signal with a passive pre-amp. (or just a stereo pot) This control would alow you to adjust the level for proper balance from the speakers.

And there is the ability to just bi-wire....

Chris
More to discover