Personnaly I have always made jumpers of the same wire as the speaker wire from the amp. See if you dealer can get you 6-8 inches of the T.labs.
Best wire metal to bridge speaker binding posts
Have a set of Kef Model 4~2 Powered by Sunfire Sig with both current and voltage binding posts
Had a set of 2 runs per speaker (think this is called Shotgun Biwire?) "Monster Z2"
Have upgraded to a single run speaker cable Tara Labs The One.
Unable to find the original binding post, to tie the speaker sections together
Any sugestions on what to use? The posts are 1 3/4 apart and the opening is 3/16 radius
I was thinking on a solid gold or plated gold bar or pin
Had a set of 2 runs per speaker (think this is called Shotgun Biwire?) "Monster Z2"
Have upgraded to a single run speaker cable Tara Labs The One.
Unable to find the original binding post, to tie the speaker sections together
Any sugestions on what to use? The posts are 1 3/4 apart and the opening is 3/16 radius
I was thinking on a solid gold or plated gold bar or pin