Belles 21A standby mode?

Turns out to be a non-issue - 21A is operating fine. I have the option of sending it back for a checkup if it makes me feel better. Sorry for all the commotion.

Jmann....have you gotten any further details or information re: the tubes in the 21A and the standby mode? My emails have not been answered yet.

Maybe this an apples to oranges comparision...
I also have a Belles 20A, plugged it back in, power swich off and there is a faint glow on the filaments. When powered on, the glow reaches the intensity that I see with the 21A powered off.

1markr, I received my L-2 Christmas day(actually arrived). I'm very impressed with it and feel it was a definite improvement over the L-1 I had previously.
Why don't you call Dave Belles and talk to him about your questions. I would think that it would have a standby mode that at least keeps the filaments heated like the AI.
Let me know about your final decisions on the preamps.

Bigtee...I'm not quite prepared to comment on the either the L2 or 21A, other than they both sound very nice and I could easily live with either of them. I just got the L2 less than a couple of weeks ago, and the 21A a week or so before that. These replaced a very highly regarded 51SE, which just did not work well in my system at all. In my system, to my ears, either of these preamps sound much better, at a quarter of the price.

In a few weeks, I should be able to formulate a meaningful comparison, as I'm going to keep only one of the preamps when all is said and done. I'm working on rolling the best tubes into these two preamps now.
The 21A, so far is just a tad noisier than the L2, but that could be tube related, thus the tube rolling.

I'll keep you posted.

I'm still trying to find out if the 21A has a standby mode, and if I'm missing a jumper.

If that's the case, then I probably shouldn't worry.
Thanks everyone for responding !!

There is not going to be a change in intensity of the light emitted from the tube filaments. The power to the filaments remains the same on or off. It's the other circuits you change.
1markr, care to comment on the comparison between the L-2 and the Belles 21A sound wise? I also have the L-2 but looked hard at the Belles. I didn't get to demo the 21A. I'm using the AI with a Belles 350A.

Dave Belles stated that a couple of units went out the door with a missing jumper. Mine could be one of them.
With the 21A powered off or powered on, there's no change in "glow intensity" of the filaments.
I also have a 20A and the chassis above the tubes gets slightly warm but there is no visible glow in any of the 4 tubes.

I have the 21A also. The standby mode keeps the tubes' filaments heated, so that the warm up time of the tubes is less than 15 minuted vs. an hour or two from a cold start. However, the rest of the tube is not powered, thereby it's life should not be severly impacted. In fact, the opposite may be true; the tubes' life may be extended due to the tubes not facing the harsh turn-on currents every time you power up the preamp. This is also the same as my other preamp, the Audible Illusions L2 preamp.

If you're not going to listen for a while, like a few days or so, I would disconnect power to the pre.