BEL 1001 MK5 driving Joseph Audio Pulsars


I own the BEL amp and considering the purchase of a used pair of the Plusars.

My concern is the Pulsars 83.5 dB sensitivity as measured in Stereophile.  They do have a benign impedance curve, not dipping below 6 ohms. This to me means a speaker that thirsts after watts as opposed to current. 

The BEL is rated at 50wpc into 8ohm and doubles down into 4 and 2 ohm loads, likely due to a very conservative 8 ohm rating. Easily drives my Esoteric MG10s (87dB sensitive, 6ohm nominal impedance) to very loud levels.

My room size is `12.5 by 14.5 x 8.5 feet.  An asset for speakers of low sensitivity.

I am looking for thoughts regarding the BEL's ability to drive the Pulsars in a modest size room.




mesch

Showing 1 response by ecolnago

Driving a pair of Pulsars (ver 1) with a pair of Mr. Karsten's Atma-Sphere M-60 mono amps (luckily thru one of his pre-amps!) in a room of the exact same dimensions described.

My tastes vary, Radiohead to Dinah Shore to Debussy to Iron & Wine, etc. etc., all in one day. On no occasion have ever felt the 60 watt amps were not enough. They can take Mighty Sam McLain's 'Too Proud' to the point where my living room windows are actually rattling (hard to believe the little Pulsars can move that much air, yet somehow they do...), and I still don't think I've tapped out all the M-60's have to give. You just wouldn't want it any louder.    

Have no experience with the BEL, but if is the solid 50 wpc I imagine it to be, I suspect you'll not want for more, less you're keen on deafness;).
Todd