I agree with both post above go slow take your time is key. I don't know how other people remove tonearm wires but I've had good luck with small thin needle nose plyers or tweezers. I put the plyers gently on tag not much pressure and with other hand holding tonearm gently and slow with my finger push the plyers close to tonearm tags. This way your not pulling the wire off the cartridge. If you like you can use a bread twisty tie to hold tone arm from coming lose from its rest to prevent arm coming lose and damaging your needle. You can down load a protractor on Vinyl Engine that matches your tonearm and email it to a print shop they will inlarge it to required size on large thick slick paper. Good luck, if you get frustrated walk away and come back later, no rush!
Beginner's Guide to Replace Cartridge on Music Hall MMF 2.2
I have a MMF 2.2 turntable and its stock cartridge started having noise on the left channel. I bought a new cartridge but have never set up a cartridge and turntable before. I also don't have the protractor template that came with the turntable originally. I looked into professional installation but it would cost almost as much as the turntable. Does anyone know where I can find some good resources to help change the cartridge on this particular turntable with no experience?