Bass: Jolida 502A + Klipsch Forte

Go to Bob Crites Klipsch site (critespeakers dot com) and purchase their titanium tweeters diaphgrams. A 20 minute project ($50.00) with amazing results

Saulgold,
The most important consideration is room acoustics. Bass traps in the corners of the room will significantly help with bass extension. I have Fortes and recently made DIY corner traps with Owens 703 rigid fiberglass. This simple, inexpensive project helped not only with bass extension but over the entire frequency spectrum. I also have 30 lbs of sand in the base of the speakers and AudioPoint brass spikes. These speakers really shine with acoustic bass. The sound is natural and live. Good luck and happy listening.
Mike

You will need to adjust the placement of the forte's, an equal distance from the side and rear walls is the place to start!!!

Things I'd check:

Are the Fortes close enough to the rear wall, I seem to remember they are designed to be close to the wall.

Bypass the dac and go audio out of the Mac. Just maybe the dac is restricting bass.

Check the Audio Out set-up in OSX of the the Mac. Application Folders>Utilities>Audio MIDI setup.

Cheap solution is to use the equalizer in iTune and punch up the bass.

A pricy what if; retube the amp.

Good Luck

Hello, I find it great that you are using the Fortes !
This is just my thoughts on getting the most out of these speakers. They need to be sealed completely. This info can be found on the Klipsch Forums. This seems to be a step that most people do not do. Sad, because I feel this is the most important step, since this is a sealed speaker.
Second step, replace all crossovers and upgrade diaphragms. Amps, tube if they have enough power for the room. If not tube, a high quality SS amp with low grain/distortion can be used. Stay away from inexpensive receivers. This speaker can produce a quality sound if a little time & effort are put into matching room, amp, preamp and speakers. I use the Fortes from 1 foot to 2 foot from the wall. These are not in my opinion the correct speaker for a small room or low level listening. However turn it up, in the right room with the best matching equipment and watch out !

Thanks for all the great advice! I'm going to try several of these suggestions and report back with my findings.

Mike, how did you get 30 pounds of sand into the bases? It's an intriguing idea.

When I purchased the speakers five years ago I noticed they seemed a bit heavier than the spec'd 56 lbs. I decided to weigh them and they tipped the scale at 85 lbs. I noticed they had plywood flush and screwed into the base. I began to remove the plywood out of curiosity and found it was sealed with caulk. After doing a search at the Klipsch website, I found pictures and details on the mod. It appears that I own the speakers that were pictured on the website. Funny thing - the seller apparently had no idea. I picked them up locally and while he and I loaded them in the car, we both commented on how heavy they were.

Since I have no comparison with the speakers prior to this mod, I can only assume that it has helped with bass response.

Im selling a pair forte 2 , about the bass? Im running a Audionics cc3 power amp and the bass is absolutely stunning!!
Very smooth , warm and and they just sound huge!!