2. amps-preamps
  3. 1354040278

Ayon Spirit III - switching 2 broken tubes

Hello,

So after 1.5 years of use I have no sound from the speakers and 2 red LED's on the back of the amp signaling that something is wrong with V2 and V3. So I'm assuming these 2 tubes have gone and now I'm in line for ordering a new set of four. Fine.

I asked my distributor if I can swap V2 and V3 tubes with the (apparently) good ones from V1 and V4 to see if now V1 and V4 will light up on the back of the amp. The distributor advised against it as it could damage the amp. I did it anyway and I'm still getting red LED's on the back for V2 and V3. Does this mean something is wrong other than the tubes? Have a damaged something by swithing about the tubes? Can I now still place the new 4 tubes without a worry?

I have also written to Ayon to get their advice and I will report back once I get a reply.

Many thanks!
norbi

Showing 1 response by xti16

xti16
1,525 posts
 
Personally I would keep the V1 & V4 tubes WHILE ordering another quad. I've had tubes arc over and they usually work for a while. I mean the longest I've had a tube that arced over last for is 4 months before it finally went to tube heaven. In fact that tube (SED 6550 winged 'C') AND it arced over 3 times in 4 months. The fact that you swapped V1/V4 with V2/V3 and the problem stayed with the V2/V3 tubes makes me think you have a tube that will fail again. My Octave has a protection circuit that doesn't take out resistor when an output tube fails.

That being said I would be afraid to put either tube (V2 or V3) back in the amp for fear it may take out another resistor.
More to discover