AVP-S How good on 2 chanel and movies?

NOt really shure what you are asking. Trying to play a movie in 2 ch will not work well at all since the center normally does 80% of the sound in dolby digital or dts. You really need 5.1 channels to use that decoding.

If you are using tow the best you can do is mono since I am not sure how you would be able to decode the center channel and split it between the tow speakers. What you really need is a souround sound processor and a pre amp wiht a HT bypass or paridity setting. Hope this helps.

The AVP-S is good for movies and fairly good for music. It doesn't draw out subtle sounds to the final degree. But it has a rich, refined sound. The AVP2 is definitely a step up for music. Better defined bass, better separation and space between the instruments. I'd say the AVP-S is better than most $800 2 channel preamps. To beat the AVP2 you'd have to go up to $1500. I heard them both against a Theta CasaNova with the Nova winning fairly handily. But with the prices they're going at these days, you're definitely getting more than your money's worth for a surround sound\music processor. It should cleanly beat your PCA2 :-).

Thanks. I intend on adding addtional speakers and what I was really asking more or less is would it be better than my pca2. Is the proceed sensitive to power cords and if so which ones seem to work best with it?

Yes, I did notice an improvement in sound over the stock power cord when I switched it out. I used a Kimber PK14. It runs around $150. There was a noticeable improvement in the bass. And the overrall sound just seemed to have more oomph. I've never heard the PK14 Gold, but it's supposed to be even a greater stepup in performance. That's about the most I'm willing to spend on a power cord however. I would even take the PK over Kimber's Palladian series some people rave about for $1040. The PK14 improves the sound without detracting or overcompensating in some areas as other more expensive cords I've heard do.

Friz 1313 just to let you know I was able to pick up a PMDT to use a transport. By far you were right, the AVP smokes my old ps audio pca2. Also are you very familiar with the AVP and PMDT because I had some technical quesitons. Well heres my question just in case someone sees this and can answer it. I'm trying to link the PMDT and AVP through there RJ45 communications ports. I'm using telephone cords (have tried 2 different ones) and can't get them to communicate with each other. Both appear to have all of they're settings set properly but will not respond to each other (i.e. turn on/off etc). Any help would be appreciated.