2. analog
  3. 131997-74046

Audio Technica AT ML-180 Cartridge Advice

Just acquired an Audio Technica AT ML-180 cartridge with broken cantilever and was looking for advice on where to get a new cantilever rebuild and what material to choose from. My preference is a new Boron cantilever but was not sure who, apart from Soundsmith, offers this service.

Also would like to know which is the best tonearm to use for this cartridge once it's fixed. It can either go on my Audiomods Series 5 (eff. mass approx. 11g) or the arm on my Yamaha GT 2000 which has an effective mass of approx. 20g.

Thanks in advance.
ateal

Showing 2 responses by harold-not-the-barrel

harold-not-the-barrel
895 posts
 
SME III w/ 5.0 g teak damped titanium nitride S-shaped want + fluid damping is designed especially for HQ HC MM cartrides. You will have a terrific combo. Good luck for searching
harold-not-the-barrel
895 posts
 
^ Quite rightly so. Ateal, your AT is a very special cartridge and deserves the best stylus there possibly exists. More precicely, it must have a miniatyre ML stylus tip ; )
More to discover