Audio Research Ref 75 SE: Replace 20A IEC inlet with 15A


Has anyone successfully replaced the 20A IEC inlet with a 15A to use a good 15A power cord?  I am currently using 2 Voodoo adapters: a 20A female to 15A male + a right-angle 15A adapter due to the depth of the amp causing it to come up against the wall.  Less than ideal, but works fine and sounds great.

Since the amp doesn't require 20A circuit it would be nice to replace the 20A inlet on the amp with a good quality 15A inlet for a direct connection to the power cord.

If anyone has done this, which 15A inlet did you use?  Does it fit well in the amp's cutout and were you able to use the existing screw on connectors to fasten the internal wires or did you have to solder them?

 

eugene81

Showing 1 response by audphile1

Swapping the cable connector is the easiest and best way to approach this. Keep the amp original. Get a good Furutech (or something similar) 20amp connector and swap it on your cable. VH Audio is an excellent source for quality connectors. Great prices and Chris can advise on what connector would fit and sound best.
One additional thought - I’d look into replacing both the male and female AC connectors on the cable.
It will most likely be an upgrade…look into Furutech FI-50 NCF. Expensive but worth every penny.