arm mass/ cartridge compliance mismatch

http://www.theanalogdept.com/cartridge___arm_matching.htm

Many thanks for your informative help. And I shall look into the Allsop Orbitrac- it sounds very interesting.

Can you hazard a guess whether a van den Hul FROG (recommended arm mass 6-10g- compliance 35u) would work in an Audio Kuzma STOGI arm (modified by removing the finger lift)? The STOGI is specified as having an effective mass of 13.5g, but that is with the finger lift- so call it 13G.

Eguth

That figure of 35 x10-6/dyne is too high. It may be STATIC compliance (at 0Hz) rather than dynamic (measured usually at 100Hz). Dynamic compliance is usually b/ween 10-40% of static.

Whatever the case may be, VdHul's recommend'n for a 6-10gr arms seems to indicate average compliance AND that yr proposed set-up consisting of Stogi+Frog is MOST likely to resonate outside the acceptable range.

ANYWAY, the formula to calculate resonant frequency (RF)is,
RF= 1000/2pi x sqrt (total mass x cu).
Cheers

Thanks for your responses. I am pleased to learn that this is not a good idea; vdH certainly will rework any of his cartridges; but at a cost. I would prefer to be sensible and either use a cartridge that suits the arm or order a special 'one off' from vdH. I have been using a vdH MC1 for many years, customised by Dr. vdH himself, with very good results.