Arm / Cart compatibility


Arm: old SME 3012, 9.5g effective wt.

Cart: old Cardas Myrtle Heart, 9.1g wt, 15 CU compliance.

*********

Is this a good marriage ?

By age-old wisdom, this SME needs a "super compliant" cart.
Is 15 CU "super compliant" ?

Table should not matter in this question (should it ?).
noslepums
Nandric, would you mind a question about your system ?
I don't have your e-mail, but you can e-mail me at:
noslepums@wavecable.com
Thank you !
http://www.theanalogdept.com/cartridge___arm_matching.htm

Get your calculator out :-)
'By age-old wisdom, this SME needs super compliant cart'?
You are probable confusing 3012 with 3009. The 3012 was/is
used with the 'old SPU' carts. Then 'the old Cardas Myrtle Heart' is probable the Benz Ruby 3 first version. To my mind no problem with either separate nor togheter.
Hi, 9.5g eff mass is not a super light arm. There are a wide range of carts that will work with the arm as far as compliance is concerned. A resonance estimator, allowing 2g for screws, gives a resonance of 9.05Hz - perfectly acceptable.
http://www.vinylengine.com/cartridge_database_tools.php#ResonanceCalculator

But this doesn't address the question if this is really a good combo. I don't know.
Regards,