Found this, but curious if anyone has done it and did a fuse swap? I’ll probably pop the cover tomorrow and see what’s inside and will post my findings if others are curious as well.
“On either end of the recess in which there are the power inlet and ports, there is a ¾” by 2” (approx..) plastic cover. There is a very slight indent on the bottom of each.
Using your fingers or a thin blade, pop off these covers.
Underneath each cap there is one small Phillips screw. The screws may be covered with a piece of transparent tape, sticky on both sides. Remove the screws, and one side of the cover pops off.”