Any recommendations for aftermarket C-7 power cord for Bluesound Node 2i

I installed the Wireworld Aurora mini on my Node 2i and am very pleased after 4 hours of listening.

Lower noise floor, so better audibility of the quietest parts of the music. Even things like the mechanical noises of piano pedals. I can hear the tube noise in some older recordings that was not previously audible.

Cleaner reproduction of all frequencies and better separation of instruments.

Very impressive improvement in bass definition and low end extension.

The C7 connector is not polarized, so you can plug it into the Node two different ways. I found a big difference in the sound of the two directions.

I'll report back if there are any changes after a week or so of use.

@buschmann,

Thanks for your post. Are you using it’s internal DAC or an external DAC with your Node 2i?  

I'm using a Yggdrasil external DAC connected with a Mogami 2964 coaxial cable and an iFi SPDIF iPurifier with UltraCap™ LPS-1 power supply.

I’m using the iFi SPDIF iPurifier as well between Node2i and dac. I have an upgraded Swagman Labs LPS and the sound from the streamer is so much better than a stock Node. Spacious soundstage, black background, more detail with smoothness in the highs.
A very worthwhile upgrade in addition to an aftermarket C7.

Another option to consider is getting a good quality C7 adapter; this gives you lots more choices for the cable.

I just recently sold my full sized DAC for an RME ADI 2 which uses C7 and then started looking for C7 cables and my list pretty much matched what everyone else has mentioned above.   I then questioned myself why I wanted to buy yet another powercord when my Shunyata Alpha Digital cable was now sitting idle so I purchased a  Cryo Treated C7 C14 Adapter from Take Five Audio and am using it with the Shunyata and RME with fine results.