2. analog
  3. 1298294842

Anti skating SME V

I am using my SME20/2A with a Dynavector XV-1s cartridge and it sounds good.

I have a question though. The cartridge tend to skip a bit (towards the spindle) when lowered on the run-in groove.
I have tried to set the anti skating to maximum (3) and this helps, but doesn't eliminate the problem. I have to be most careful when lowering the arm to avoid skipping. I also found that playing a bit with the position of the din-connection, turning it anti clockwise seen from the top, might have helped (not sure), but did not eliminate the problem either. Is there a special position for this connection that is preferable? Will the position of the cable affect the anti skating in any way? I have tried to lower the cartridge on a blank record and the arm goes quite fast towards the spindel even with max anti skating (never experience this problem on my Dynavector arm). I know this is not the correct way to set anti skating, but it should give an indication.

Anybody?
fosse

Showing 1 response by sounds_real_audio

sounds_real_audio
953 posts
 
This could happen because as the stylus first touches the grooves it has hardly any tracking force on it until it settles in to its set tracking force.
You might try lowering the stylus closer to the first music grooves. The edge of the records has a pretty sever bump and if the stylus lands there it will tend to skid inward.
More to discover