2. analog
  3. 1298294842

Anti skating SME V

I am using my SME20/2A with a Dynavector XV-1s cartridge and it sounds good.

I have a question though. The cartridge tend to skip a bit (towards the spindle) when lowered on the run-in groove.
I have tried to set the anti skating to maximum (3) and this helps, but doesn't eliminate the problem. I have to be most careful when lowering the arm to avoid skipping. I also found that playing a bit with the position of the din-connection, turning it anti clockwise seen from the top, might have helped (not sure), but did not eliminate the problem either. Is there a special position for this connection that is preferable? Will the position of the cable affect the anti skating in any way? I have tried to lower the cartridge on a blank record and the arm goes quite fast towards the spindel even with max anti skating (never experience this problem on my Dynavector arm). I know this is not the correct way to set anti skating, but it should give an indication.

Anybody?
fosse

Showing 1 response by lewm

lewm
12,522 posts
 

I'd love to see how they calibrate a new spring.

Per ordering the Wally Skater, do what properly?  Set antiskate? With that response from SME, I think it adds weight to the idea not to use a blank LP to set AS.  And yet, the posts on doing it that way will keep on coming.

 

More to discover