If you have the time and the funds use Soundsmith. I did not and used Andy to straighten my stylus on my Lyra. A fair price but a little longer turn around then promised. When I got it back the length of the needle was so short the body now rested on the surface of the record. I sent photos of what it should look like compared to what it does now and was told that is not the same cartridge. After much back and forth, Andy felt the problem was my tracking force settings, never an issue before. At his request and at my cost I returned it to Andy to take a second look. Andy offered to replace the stylus but was leery of changing the cartridge from its original state. I agreed. He suggested I remover the white film, paper? to make it a nude cartridge, not an option to me. You can still see a very slight angle on the stylus, as if the it shortened as far it could be. Andy denies this. I now have a maximum tracking force of 1.5 and a little brush handy to clean the underbody. Andy is no Peter L.
Andy Kim - Needle Clinic
I wanted to put this post out there about Andy Kim of Needle Clinic, located in Bellevue, Washington. As many may know, Andy is a cartridge re-tipper. I tried to find some older posts to add my comments but couldn't find them. So I'll start another OP. I just got my Lyra Kleos back from Andy today. Here's my comments.
My Kleos sounded a little off lately, so I thought it should be checked out. I sent it to Andy Kim. It turns out all that was needed was the stylus required a cleaning and polishing. Andy reported back that the stylus only has about 10 percent wear; IOW plenty of life left.
So I remounted the Kleos today and have been playing all types of music: rock and roll, classical, and so forth. The Kleos sounds wonderful; just great. Kudos to Andy Kim.
Fyi -- some may ask why I didn't send it to Peter Ledermann at Sound-Smith. I seem to recall reading somewhere that he's been unusually busy lately -- and with good reason -- and turn around might be a bit delayed. Also, I'm not sure Peter uses replacement cantilever/stylus assemblies that match (or at least come close to) the original. Andy does.
Anyway, that is a bridge I don't have to cross today.
Bottom line: Andy turned my cartridge within a week of receipt and I am pleased.
My Kleos sounded a little off lately, so I thought it should be checked out. I sent it to Andy Kim. It turns out all that was needed was the stylus required a cleaning and polishing. Andy reported back that the stylus only has about 10 percent wear; IOW plenty of life left.
So I remounted the Kleos today and have been playing all types of music: rock and roll, classical, and so forth. The Kleos sounds wonderful; just great. Kudos to Andy Kim.
Fyi -- some may ask why I didn't send it to Peter Ledermann at Sound-Smith. I seem to recall reading somewhere that he's been unusually busy lately -- and with good reason -- and turn around might be a bit delayed. Also, I'm not sure Peter uses replacement cantilever/stylus assemblies that match (or at least come close to) the original. Andy does.
Anyway, that is a bridge I don't have to cross today.
Bottom line: Andy turned my cartridge within a week of receipt and I am pleased.