2. amps-preamps
  3. 195459-101923

Amplifier recommendations for 86 dB Sensitivity Speakers

Hi,

I’m considering a pair of Technics SB-G90M2, they have good specifications on paper; however, my only concern would be their 86 dB sensitivity. 

My current amplifier is Cayin A100t, which according to its specs, outputs 70 watts into 8ohms. the Technics are 4 Ohms; so, I assume my Amp could deliver 100-140 Watts into 4 Ohms. Unfortunately, I couldn’t find more accurate information about my amplifier, and it only shows the output power at 8 Ohms equipped with KT-88 output tubes (mine came with EL-34s), therefore, it’s unclear what the real output powerat 4 ohms is.

Wondering if this tube amplifier would be a good match for these more demanding 86 dB speakers? I’m aware of impendence fluctuations and I know the Amp can drive them just fine, but I am not sure if 100 watt per channel -assuming that’s what my Amp can deliver into 4 Ohms- would be enough for these speakers to make them sound as intended, meaning, good sound quality.

(I don’t nor am planning to listen at high volume but have a larger room with high ceilings).

Below are the specs.

Many thanks,

 

Technics SB-G90M2 Speakers 

  • Type: 3-way floorstanding speaker with bass reflex
  • Woofer: 2 x 16 cm
  • Midrange: 16 cm
  • Tweeter: 2.5 cm
  • Sensitivity: 86 dB
  • Impedance: 4 ohms
  • Frequency range: 33 Hz – 90 kHz (-10 dB)
  • Crossover frequencies: 500 Hz, 3400 Hz
  • Maximum power handling: 200 W
  • Recommended amplifier power: 40-200 W
  • Dimensions and weight: 111.4 x 29.2 x 36.6 cm / 35 kg

 

Cayin A100T Integrated Tube Amplifier 

Power output: 70 watts per channel into 8Ω (stereo)

Frequency response: 10Hz to 65kHz

Total harmonic distortion: 1%

Input sensitivity: 480mV (line)

Signal to noise ratio: 89dB (line)

Speaker load impedance: 4Ω to 8Ω

Valve complement: 8 x KT88, 2 x 12AU7, 2 x 6CG7, 1 x 12AX7

Dimensions: 440 x 210 x 397mm

Weight: 29kg

mamifero

Showing 2 responses by soix

soix
10,397 posts
 

the Cayin will be able to output adequate power but I might be missing out their full potential. 

Exactly.  Plus pushing an amp close to its limits will sacrifice ultimate sound quality on that end as well.  It’s a bit more expensive, but I’d recommend looking at the ProAc D20 as it may share many of the same characteristics while being easier to drive.  Best of luck. 

soix
10,397 posts
 

Given the low sensitivity and that the speakers probably drop below 4 Ohms at certain points I think you’d be really pushing it with your amp.  There are lots of good speakers out there at that price point so I’d look for something else if you want to keep your amp. 

More to discover