2. amps-preamps
  3. 1359572332

Advice on bias range setting

In the CAD-280SA (V12R with EL34s) manual, Cary states that the bias has a minimum of 220mA and a recommended range of 250-275mA. I have it currently set to 250mA. But before making any changes I was hoping for some advice from the experienced....Why is there a range and not a fixed bias value? Will it sound different at the extremes (220 & 275)? Does this effect tube life? Power consumption? It can't get any hotter can it?
mysearcher257
5 responses Add your response
rrog
1,958 posts
 
The recommended range is 250-275. Why would you consider anything else? Whenever there is a range I always use the higher setting because it sounds better.
rodman99999
6,130 posts
 
The higher setting will yield a more dynamic sound. VERY slightly harder on tube life. I run my Cary monoblocks in the middle of their recommended range of 150 to 175mA(about 163 mA). I'm using SS below 250Hz, so- I'm not losing anything down there.
polk432
1,142 posts
 
I had a Cary V12R and was told by Cary to run it around 240 mA and it always ran fine. You don't need it any hotter. I swear I could cook a hamburger on the one I had.
rrog
1,958 posts
 
"The higher setting will yield a more dynamic sound."

A little cleaner, more open and better bass too.
gdshasko
6 posts
 
i have cary v12r 240ma is about right,or about 38ma per tube.you can run 4tubes or 8 or 12tubes on the v12r.start in the middle toggle switch,one on each side of the toggle switch. 4tubes is about 1/3 power.8tubes 2/3 power 12 tubes full power.this is a good way to try different tubes.
Log in to respond
More to discover
80x80
TriangleART L200 MK2 Dual Mono Tube Preamplifier
80x80
Zesto Audio Leto 1..0 Preamplifier
FREE SHIPPING!!
80x80
Zanden Audio 8120