Replace the tweeters with the stock replacements. Play some music with your ear next to the tweeters on the speaker before and after you replace them. They should sound a little weird but you'll hear the difference between good tweeters and broken tweeters.
Advice needed: replacing tweeter in PSB Image 4T
On a lark I purchased a pair of PSB Image 4Ts for my brother in law who is using bookshelves in a 25 foot ceiling room, thinking these would be more enjoyable to use until his budget allows him to get what he wants. They are in pristine exterior condition, but just don’t sound right to either of us. At first I attributed this to comparing them to the Imagine Ts I have, which I really enjoy. The sound coming from the tweeters is markedly off, almost tinny and somewhat faint, leading me to conclude the tweeters are not working as they should rather than the inherent performance of this speaker, which seems to have pretty good reviews. This was reinforced by online references to some PSB speakers being prone to having tweeter issues.
A couple of sources recommended replacement with Peerless by Tymphany BC25SC06-04 1” textile dome tweeter as a perfect match (different material notwithstanding), just “swap and done”. However, others stated that the differences in specs for impedance (6 ohms vs 4 ohms) and sensitivity (89db/2.83V/m vs 96.2db/2.83V/m) between the PSB and replacement part respectively needed to be compensated for with modifications way above my knowledge level to understand or implement. On the plus side the tech support guy where I purchased the replacements (only $35/pair) said put them in and if I don’t like the sound just return them, which is what my plan is right now, fingers crossed.
Any advice/thoughts is greatly appreciated!
A couple of sources recommended replacement with Peerless by Tymphany BC25SC06-04 1” textile dome tweeter as a perfect match (different material notwithstanding), just “swap and done”. However, others stated that the differences in specs for impedance (6 ohms vs 4 ohms) and sensitivity (89db/2.83V/m vs 96.2db/2.83V/m) between the PSB and replacement part respectively needed to be compensated for with modifications way above my knowledge level to understand or implement. On the plus side the tech support guy where I purchased the replacements (only $35/pair) said put them in and if I don’t like the sound just return them, which is what my plan is right now, fingers crossed.
Any advice/thoughts is greatly appreciated!