Adding a step-up transformer

I just went through the same process, adding an EAR MC3 in between my Karat and my Herron Phono-pre. Fantastic results!

The EAR gives you three taps to choose from and the 40 ohm one is a near prefect match for the Karat.

Make sure you run a ground wire between the EAR and your Phono-pre, and keep all wireing away from digital sources, mine picked up a hum untill I segregated the components.

Dave

When I was into MC cartriges I had a Signet transformer. When I replaced my preamp, I got one with a MC input (Tandberg) because I thought that transformers in general were a bad idea. Not so. The Signet transformer was perfectly OK. (It ought to be.. it cost as much as the preamp!).

Check the new ones John Chapman is putting together, complete with cool little machined cases, etc.: http://www.bentaudio.com/

Looks like great work, and the price is very right.

-Ed

Part of the needs come from the preamp gain also. You are looking for the total gain number that comes out of the preamp outputs. I see from your statements that your phono stage is 65db gain, which means your preamp must have a low gain figure. They Karat wants a total of about 86db total gain(phono stage + preamp). So you will want another 20db. A transformer would be about right for this application.

The normal rules are to get one that is the correct amount of gain increase that you need, run it into the 47k load on the phono stage inputs, and load the cartridge at the transformer inputs, at about 1/2 the value of the recommended setting for direct input.

As with any transformer, there are good and great ones. Cost is a factor because great transformers are not real cheap. For new ones, you can expect to pay around $1k, and maybe around $400 used. The best are supposed to be the SU-1 and Audio Note Kondo which are both over $5k. Reasonably priced ones would be a used M.A. Cotter Mk2 or an EAR MC-3, or a Bent Audio unit with TX-103 transformers.