Adding a phono stage component ? Advice needed

Hmmmm.........thanks kindly!! You gave some where to start!

Thanks a lot Rockvirgo & Oldears. I had a preamp with a phono stage but sold it when I aquired my new one. Your probably right saying that I should get a dedicated phono stage. Thanks for the help..................

I haven't done anything at this point. I'm still trying to decipher the best overall move. I did buy a new Rega p-25 but I'm still undecided on what phono stage to get. I believe I'm going to go with a Dynavector 20x cartridge or a Rega Exact. I could sure use some input as to what direction to go now that I've made it this far. I believe it makes a lot of sense to go with the phono preamp since I don't have another preamp laying around. I've considered the Rotel along with a Rega EOS. Tube or solid state? Which way to go ? I'd like to keep it in a budget range of 500 to 600. There is to much info and products for a uneducated individual. I appreciate everyones input too. I'm open for suggestions in the worst of ways. Help !!!!!!!

Jim you have helped ease my mind in a couple of areas. I've heard the hum issue all to many times now about Grado. If I could get some Dynavector vs Rega input. Then I could narrow that decision to the point. I'm also starting to believe that Rotel isn't a viable candidate either. I think I will call Jerry and see what he recommends. The point of obtaining a phono pre with both capabilities is a must. Ok thanks and I'll wander a little more. Hopefully I can gain enough knowledge and make a sound choice here! Thanks again.

Your right. For a flu sickened individual your pretty sharp!!! I hope your feeling better soon.........