I have an Acoustat TNT 200 that makes a click noise inside the amp while operating. I noticed this when I had the stereo at a very low volume. The sound from the speakers is perfectly fine no unusual noise ect. is this normal for this type of amp, or could there be a problem?
It's normal. The stainless steel chassis is the reason. If you leave the amp on all of the time, it will stop after a day or two. Nothing to worry about. Don
Thanks for the response. One last question if I may..I also noticed (hard not to) that it makes a whir like sound and slight hum when powering up then becomes clear. Takes about 2 seconds. Is this too normal?
Mine also..I had one for several years and did the exact same thing.Temperature variations within the stainless steel chassis is the usual cause...no big deal. Fine sounding amp with mosfet output.Although mine got a bit noisy in the right channel(hiss) but was not major. Good listening!
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.
