Accuphase E-260 Voltage Conversion (100V to 230V)

@imhififan 

@frankhhh 

i sent you a direct message. Thanks

@jgore 

The message system does not support links, why not post them to this forum?

Hi @imhififan 

i just have a question regarding the conversion on the e-270. 
If following the voltage conversion table to 120v from the e-260 service manual, and apply the rewiring on the e-270, it turns out that pin 2 should be black and pin 4 should be orange. 
as both cables are 100v, I’m wondering if there would be any difference from your proposed cabling scheme above?

Thanks so much. 

If following the voltage conversion table to 120v from the e-260 service manual, and apply the rewiring on the e-270, it turns out that pin 2 should be black and pin 4 should be orange.

@jgore 

Pins 2 and 4 are not connected to any part of the circuit, they are there to house unused wires. So it doesn’t matter if the black and orange wires are on pin 2 or pin 4.

Connect the yellow and brown wires to pin 3 to set the voltage to 120V.

Hope this helps.