I find my system completely satisfying at 70 - 80 or below. Additionally safety standards are guidance and I would prefer to be no where near the limits, they easily could be too high as well as low. I would not want to put my hearing in jeopardy. Also, standards virtually never go up they go down as more studies come in and more folks with compromised hearing are sampled. I love the way some folks see conspiracies everywhere. Common sense… a worthwhile thing to have.
300B SET Amp driving Wilson Sabrinas
Interesting experience to share.
In my home system I have a pair of Wilson Sabrina speakers normally driven by a Modwright KWA 150SE (Special Edition). On a lark, I replaced the Modwright with an Elekit 8600S 300B amp (Lundahl output transformers and Mundorf Supreme output capacitors) I had in another system.
The surprise, not only did the Elekit drive the Sabrinas very well (improved clarity and tonality), but at the same volume with the same input level as the Modwright! Using a passive preamp, when I set the volume knob on the preamp to the same point for both the Modwright and the Elekit it results in essentially the same volume from the speakers.
Admittedly I listen at moderate levels (SPL rarely exceeds 70dBA), but the sensitivity of the Sabrinas is only 88 dB. Who would have thought!!
Showing 4 responses by ghdprentice
👍 Pairing of low powered tube amps can be incredibly informative. First that speakers are far less sensitive to tube amp power… way more than you would think. You put a low power solid state amp in there like a Pass kit and it would sound dead and completely underpowered. Also, the midrange produced by a 300b tube amp can be pretty intoxicating. I had done this recently.
My ARC tube amp can be run in triode mode 70wpc or linear, 140wpc. Virtually no difference in volume or dynamics (my speakers 90db efficient). @mijostyn +1. Pass XA200… or even better an ARC 160 amp. |