3/8 thread Spikes...

Hi Peter,

I am actually looking for the coarse thread 3/8 by 16 for their spikes.

Where can i find them?

Thanks

At a higher price point check out 3/8 16 brass Audiopoints.

http://www.starsoundtechnologies.com/shopping.html

AP platforms and points have been a significant upgrade for my Merlins and other components.

Our Sound Anchor stands have a 3/8”-16 thread size on one model and a 1/4”-20 on the other.

If you want to give your stands a big sonic upgrade we would recommend giving Star Sound Audio Points a call. We just purchased B stock end of the year closeouts at a good price and the Audio Points improved sound on all levels as advertised. Hope this helps.

Hello Clarrie

Send me an email with your address and Ill put 8 with nuts and washers in the mail for you. You can email me form my website pbnaudio dot com

Thanks

Peter

Reviving this thread because I also need 3/8 inch thread speaker spikes for the stands to my Vandersteen 1Cs.

The documentation says they're 1/4 20, but after trying those and finding they were way too small I purchased a few different sizes of carriage bolts at the local hardware store and tried them until I found the right one: 3/8.

These appear to be old Sound Anchor stands, though I can't find any markings on them, and they seem different from any other pair I've seen in pictures. Looks like they weren't stored terribly well and I'll need to sand them down and repaint them.

I've done a lot of searching, and all I can find are 1/4 20 and 6mm. I looked at the sites listed above from a couple years ago, and no luck.

Any advice?